Toyota Sienna Service Manual: Airbag system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
Precaution
Caution:
The vehicle is equipped with a supplemental restraint
system (srs). It consists of a driver airbag, front
passenger airbag, front seat side airbag, curtain shield
airba ...
Other materials:
Park / Neutral Position Switch Circuit
DESCRIPTION
The clearance warning ECU receives the reverse or park position signal from
the park / neutral position
switch.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT CLEARANCE WARNING ECU
Disconnect the C9 connector from the clearance warning
ECU.
Measure the voltage ...
Terminals of ECU
1. MULTIPLEX NETWORK GATEWAY ECU
Disconnect the G4 ECU connector.
Measure the voltage between the specified
terminals on the wire harness side connector.
If the result is not as specified, there may be a
malfunction on the wire harness side.
Measure the resistance between ...
Initialization procedure
(a) Make sure that the ignition switch is off.
(b) Connect the intelligent tester to the DLC3.
(c) Turn the ignition switch to the ON position.
(d) Select "TIREPRESS" by following the prompts
displayed on the intelligent tester.
(e) Press the tire pressure warning reset sw ...