Toyota RAV4 manuals

Toyota Sienna 2010-2018 Owners Manual: Audio system types

Owners of models equipped with a navigation system should refer to the “NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MANUAL”.

Using cellular phones

Interference may be heard through the audio system’s speakers if a cellular phone is being used inside or close to the vehicle while the audio system is operating.

NOTICE

To prevent battery discharge

Do not leave the audio system on longer than necessary when the engine is off.

To avoid damaging the audio system

Take care not to spill drinks or other fluids on the audio system.

Basic Operations
...

Audio system
Operations such as listening to audio, using the hands-free phone, confirming vehicle information and changing audio system settings are started by using the following buttons. ...

Other materials:

Installation
1. INSTALL TRANSAXLE HOUSING OIL SEAL (a) Using SST and a hammer, install a new oil seal. SST 09316-60011 (09316-00011) Oil seal installation depth: -0.5 to 0.5 mm (-0.020 to 0.020 in.) (b) Coat the lip of the oil seal with MP grease. 2. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEA ...

Insufficient Coolant Temperature for Closed Loop Fuel Control
DESCRIPTION Refer to DTC P0115 (See page ES-133). MONITOR DESCRIPTION The resistance of the ECT sensor varies in proportion to the actual ECT. The ECM supplies a constant voltage to the sensor and monitors the signal output voltage of the sensor. The signal voltage output varies acc ...

Installation
1. INSTALL CRANKSHAFT POSITION SENSOR  Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.  Install the crankshaft position sensor with the bolt. Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)  Connect the crankshaft position sensor connector. ...

© 2011-2018 Copyright www.tsienna.net