Toyota RAV4 manuals

Toyota Sienna 2010-2018 Owners Manual: Bluetooth® phone settings

You can adjust the hands-free system to your desired settings.

Using the steering wheel switches
The steering wheel switches can be used to operate a connected cellular phone. Operating a telephone using the steering wheel switches Volume switch Increase/Decrease the volume Pres ...

“Phone/Message Settings” screen
To display the screen shown below, press the “SETUP” button, and select “Phone” on the “Setup” screen. Set the phone connection Setting the sound Contact/Call History Settin ...

Other materials:

Display check mode
HINT:  This mode checks the color display on the display.  Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle. 1. ENTER DIAGNOSTIC MODE 2. D ...

Installation
1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH (a) Install the hub & Bearing assembly LH with the 4 bolts. Torque: 56 N*m (571 kgf*cm, 41 ft.*lbf) 2. INSPECT BEARING BACKLASH (See page AH-16) 3. INSPECT AXLE HUB DEVIATION (See page AH-16) 4. CONNECT SKID CONTROL SENSOR WIRE (a) Co ...

Sensor signal check by test mode (signal check) (when using intelligent tester)
(a) When having replaced the skid control ECU and/or yaw rate and deceleration sensor, perform zero point calibration of the yaw rate and deceleration sensor. HINT: If the ignition switch is turned from the ON position to the ACC or off during test mode (signal check), DTCs of the signal ...

© 2011-2018 Copyright www.tsienna.net