Toyota RAV4 manuals

Toyota Sienna Service Manual: CD Player Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal/ CD Changer Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal

Toyota Sienna Service Manual / Audio / visual / Audio and visual system / Diagnostic trouble code chart / CD Player Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal/ CD Changer Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal

DTC 62-10 CD Player Mechanical Error

DTC 62-11 CD Insertion and Ejection Error

DTC 62-12 CD Reading Abnormal

DTC 63-10 CD Changer Mechanical Error

DTC 63-11 CD Insertion and Ejection Error

DTC 63-12 CD Reading Abnormal

DESCRIPTION

DTC No.

DTC Detecting Condition

Trouble Area

62-10 A mechanical error in the CD player is detected while the CD is not being inserted or ejected. Radio receiver
62-11 CD insertion or ejection is failed.
62-12 CD read problem occurs.
63-10 A mechanical error in the CD changer is detected while the CD is not being inserted or ejected.
63-11 CD insertion or ejection is failed.
63-12 CD read problem occurs.

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 REPLACE RADIO RECEIVER

END

Disc cannot be Played/ No Playable Files/ Copyright Protection Error
DTC 44-7D Disc cannot be Played DTC 44-7E No Playable Files DTC 44-7F Copyright Protection Error DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-7 ...

Wrong Disc/ Disc cannot be Read/ Wrong Disc/ Disc cannot be Read
DTC 62-41 Wrong Disc DTC 62-42 Disc cannot be Read DTC 63-41 Wrong Disc DTC 63-42 Disc cannot be Read DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 62 ...

Other materials:

Power Back Door Warning Buzzer does not Sound
DESCRIPTION The power back door system uses a warning buzzer built into the back door, which has 3 ways of sounding that are used differently according to the situations: When all the following conditions are met, the warning buzzer sounds at a cycle of 0.3 seconds: * The ignitio ...

Lubrication system
On-vehicle inspection 1. CHECK ENGINE OIL LEVEL (a) Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark. If the engine oil level is low, check for leakage and add oil up to the full level mark. NOTICE: D ...

Steering Angle Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Steering Angle Sensor Communication Stop Mode "Steering angle sensor" is not displayed on the "Communication Bus Check" screen of the intelligent tester Applies to &qu ...

В© 2011-2019 Copyright www.tsienna.net