Toyota RAV4 manuals

Toyota Sienna 2010-2021 Owners Manual: Command list

Some recognizable voice commands and their actions are shown below as examples.

Command

Action

“Help” Prompts voice guidance to offer examples of commands or operation methods
“Go Back” Returns to the previous screen

Command

Action

“Redial” Places a call to the phone number of the latest outgoing call
“Call Back” Places a call to the phone number of latest incoming call
“Show Recent Calls” Displays the call history screen
“Dial <phone number>” Places a call to the said phone number
“Call <contacts> <phonetypes>” Place a call to the said phone type of the contact from the phone book
Casual speech recognization
Due to natural language speech recognition technology, this system enables recognition of a command when spoken naturally. However, the system cannot recognize every variation of each command. In ...

Mobile Assistant
The Mobile Assistant feature will activate Apple’s Siri® Eyes Free mode via the steering wheel switches. To operate the Mobile Assistant, a compatible cellular phone must be registered and conn ...

Other materials:

Vehicle Speed Sensor Malfunction
DTC P0500 Vehicle Speed Sensor Malfunction DTC P0503 Vehicle Speed Sensor "A" Intermittent / Erratic / High DESCRIPTION The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform the diagnosis using th ...

Back Door Closer Switch Malfunction
DTC B2215 Back Door Closer Switch Malfunction DESCRIPTION This DTC is output when a malfunction occurs in the position switch in the back door. This position switch detects if the back door is in the latch position and sends a position signal to the power back door ECU. DTC No. ...

Air-fuel ratio (a/f) and heated oxygen (ho2) sensor heater monitors (front a/f and rear ho2 sensor type)
(a) Preconditions The monitor will not run unless: The MIL is OFF. (b) Drive Pattern (1) Connect an intelligent tester to the DLC3. (2) Turn the ignition switch to the ON position. (3) Clear the DTCs. (4) Start the engine. (5) Allow the engine to idle for 10 minutes or more. ...

© 2011-2021 Copyright www.tsienna.net