Toyota Sienna Service Manual: High Temperature
DTC 58-45 High Temperature
DTC 80-45 High Temperature
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
58-45 |
High map disc player temperature is detected (Over 80C). | Radio and navigation assembly |
|
80-45 |
High map disc player temperature is detected (Over 80C). |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs.
1 CHECK RADIO AND NAVIGATION ASSEMBLY
- Park the vehicle in a cool place.
- Check that the temperature of the radio and navigation assembly has becomes sufficiently low, then start the engine to verify the malfunction symptom.
OK: Same problem does not occur.
END
Player Error
DTC 58-44 Player Error
DTC 80-44 Player Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
58-44
Map player error is detected
Radio and navig ...
Camera Picture Error
DTC 5C-40 Camera Picture Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from the camera cannot be
transmitted.
...
Other materials:
Speed sensor check (when using sst check wire)
(a) Check the speed sensor signal.
(1) Drive the vehicle straight forward. Drive the
vehicle at a speed of 45 km/h (28 mph) or higher
for several seconds and check that the ABS
warning light goes off.
HINT:
The signal check may not be completed if the
vehicle has its wheels spun or the stee ...
For vehicles equipped with traction control (trac) system
When using a 2-wheel drum tester such as a
speedometer tester or chassis dynamometer, etc., or
jacking up the front wheels and driving the wheels,
always push in the TRAC cut ("TRAC OFF") switch and
turn the TRAC system OFF.
FOR VEHICLES EQUIPPED WITH TRACTION CONTROL (TRAC) SYS ...
Removal
1. REMOVE INSTRUMENT CLUSTER FINISH PANEL
CENTER NO.1 (See page IP-8)
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL
CENTER NO.2
3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
HINT:
(See page AX-146 for U151E, AX-146 for U151F)
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL
ASSEMBLY CENTER (See page IP-9)
5 ...