Toyota Sienna Service Manual: Precaution
- Basic repair hint
- For vehicles equipped with srs airbag and seat belt pretensioner
- Electronic control
- Removal and installation of fuel control parts
- Removal and installation of engine intake parts
- Handling of hose clamps
- For vehicles equipped with mobile communication systems
- When servicing full-time 4wd vehicles
- For vehicles equipped with traction control (trac) system
- For vehicles equipped with vehicle stability control (vsc) system
- When towing full-time 4wd vehicles
- For vehicles equipped with catalytic converter
- Precaution for cooling fan system
Basic repair hint
(a) HINTS ON OPERATIONS
BASIC REPAIR HINT
1
Attire
• Always wear a clean uniform.
• Hat and safety shoes must be worn.
2
Vehicle protection
Prepare a grill ...
Other materials:
TC and CG Terminal Circuit
DESCRIPTION
DTC output mode is set by connecting terminals 13 (TC) and 4 (CG) of the
DLC3. The DTCs are indicated
by blinks of the tire pressure warning light.
WIRING DIAGRAM
HINT:
When each warning light blinks continuously, a ground short in the wiring of
terminal TC of the DLC3 or an ...
Brake Warning Light Remains ON
DESCRIPTION
If the ECU detects a trouble, it turns on the brake warning light at the same
time of prohibiting ABS
control.
At this time, the ECU records a DTC in memory.
Connect terminals TC and CG of the DLC3 to make the brake warning light blink
and output the DTC.
WIRING DIAGRAM
...
Disassembly
1. REMOVE GENERATOR CLUTCH PULLEY
(A) using a screwdriver, remove the generator pulley
cap.
(b) Set SST (A) and (B).
SST 09820-63020
(c) Clamp SST (A) in a vise.
NOTICE:
Be sure to fix the flat surface of SST (A) in a
vise.
(d) Place the rotor shaft end int ...