Toyota RAV4 manuals

Toyota Sienna 2010-2020 Owners Manual: Preparations to use wireless communication

Toyota Sienna 2010-2020 Owners Manual / Audio system / Connecting Bluetooth / Preparations to use wireless communication

The following can be performed using Bluetooth® wireless communication:

In order to use wireless communication, register and connect a Bluetooth® device by performing the following procedures.

Connecting Bluetooth
...

Device registration/connection flow
...

Other materials:

Driver Side Seat Belt Warning Light does not Operate
DESCRIPTION When turning the ignition switch to the ON position, the combination meter assembly communicates with the supplemental restraint system by the multiplex communication system. Unless the driver side seat belt is fastened, the combination meter assembly will turn on the seat belt ...

Removal
CAUTION:  Wear safety gloves, because the sharp surfaces of the seatback frame and seat adjuster may injure your hand.  Work must be started more than 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from ...

Installation
1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (a) Install the drive shaft to the axle carrier. NOTICE: Be careful not to damage the boot and ABS speed sensor rotor to the drive shaft and oil seal of the axle hub bearing. (b) Align the matchmarks and connect the drive shaft to the side gear shaf ...

© 2011-2020 Copyright www.tsienna.net