Toyota Sienna 2010-2019 Owners Manual: Safety Connect

Toyota Sienna 2010-2019 Owners Manual / Interior features / Using the other interior features / Safety Connect

Safety Connect is a subscription-based telematics service that uses Global Positioning System (GPS) data and embedded cellular technology to provide safety and security features to subscribers.

Safety Connect is supported by Toyota’s designated response center, which operates 24 hours per day, 7 days per week.

Safety Connect service is available by subscription on select, telematics hardware-equipped vehicles.

By using the Safety Connect service, you are agreeing to be bound by the Telematics Subscription Service Agreement and its Terms and Conditions, as in effect and amended from time to time, a current copy of which is available at Toyota.com. All use of the Safety Connect service is subject to such then-applicable Terms and Conditions.

Calibrating the compass

The direction display deviates from the true direction determined by the earth’s magnetic field. The amount of deviation varies according to the geographic position of the vehicle. If you c ...

System components

Microphone LED light indicators “SOS” button ...

Other materials:

Lubrication system
On-vehicle inspection 1. CHECK ENGINE OIL LEVEL (a) Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark. If the engine oil level is low, check for leakage and add oil up to the full level mark. NOTICE: D ...

Removal
1. REMOVE REAR DOOR SCUFF PLATE LH 2. REMOVE REAR DOOR WEATHERSTRIP LH 3. REMOVE BACK DOOR WEATHERSTRIP 4. REMOVE BACK DOOR SCUFF PLATE 5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH 6. REMOVE POWER POINT SOCKET ASSEMBLY Release the 2 claw fittings and remove the power point soc ...

Installation
1. INSTALL CRANKSHAFT POSITION SENSOR Apply a light coat of engine oil to the O-ring on the crankshaft position sensor. Install the crankshaft position sensor with the bolt. Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) Connect the crankshaft position sensor connector. ...