Toyota RAV4 manuals

Toyota Sienna Service Manual: System description

1. OUTLINE

HINT: MP3 is short for MPEG1 (Moving Picture Expert Group Phase 1) & 2 Audio Layer 3.

It is an audio compression standard set by a working group (MPEG) of the ISO (International Standards Organization). MP3 is able to compress audio data to about 1/10 the level of a conventional disc.

2. FUNCTION OF MAIN COMPONENTS

Television display assembly
  •  Control Panel
  •  DVD Player
  •  Headphone Terminal
  • Displays DVD and Video images.
  • Receives signals from the remote controller.
  • Outputs audio signals to the wireless headphones in the form of infrared signals.
  • Outputs audio signals to the wired headphones that are connected.
  • Adjusts the volume of the wired headphones in accordance with volume control
Radio and navigation assembly (*1) Radio receiver (*2)
  • Receives audio signals from the television display assembly and outputs them to the stereo component amplifier.
  • Enables or disables the function of the remote controller for the television display assembly
Remote Controller (Switch assembly) Outputs various control signals of the RSE system to the television display assembly in the form of infrared signals.
Wireless headphones
  • Receives the audio signals from the television display assembly in the form of infrared signals.
  • Volume adjustment of the wireless headphones can be done by using the volume control on the wireless headphones
VTR terminal This terminal is for connecting a video player's video and audio output terminals

*1: with Navigation System
*2: without Navigation System

Rear seat entertainment system
PARTS LOCATION SYSTEM DIAGRAM ...

How to proceed with troubleshooting
1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS Interview the customer and confirm the trouble. Confirm the problem by duplicating the conditions described by the customer 3 ...

Other materials:

Disassembly
1. HOLD VANE PUMP ASSEMBLY (a) Using SST, hold the vane pump assembly in a vise. SST 09630-00014 (09631-00132) 2. REMOVE POWER STEERING SUCTION PORT UNION (a) Remove the bolt and the power steering suction port union from the vane pump front housing. (b) Using a screwdriver, remove ...

Disassembly
1. REMOVE REAR DOOR WINDOW FRAME MOULDING REAR LH (See page ET-31) 2. REMOVE REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY LH (See page ET-32) 3. REMOVE SLIDE DOOR WINDOW GARNISH LH Fully open the slide door window. Remove the glass run. Using a screwdriver, disengage the clip and rem ...

Removal
HINT:  Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: Wait for 90 seconds ...

В© 2011-2020 Copyright www.tsienna.net