Toyota RAV4 manuals

BMW 3 Series 2018-2022 Owners Manual: Activating/deactivating popup windows

BMW 3 Series 2018-2022 Owners Manual / General settings / Activating/deactivating popup windows

For some functions, popup windows are displayed automatically on the Control Display.

Some of these popup windows can be activated or deactivated.

Via iDrive:

1. "CAR".

2. "Settings".

3. "General settings".

4. "Pop-ups".

5. Select the desired setting.

The setting is stored for the driver profile currently used.

Activating/deactivating the display of the current vehicle position

Concept

If vehicle tracking has been activated, the current vehicle position can be displayed in the BMW Connected app or in the ConnectedDrive customer portal.

Activating/deactivating

Via iDrive:

1. "CAR".

2. "Settings".

3. "General settings".

4. "Data privacy".

5. "Connected app and cust. portal" Select the desired setting.

Control Display

Brightness

Via iDrive:

1. "CAR".

2. "Settings".

3. "Displays".

4. "Control display".

5. "Brightness at night".

6. Turn the Controller until the desired brightness is set.

7. Press the Controller.

The setting is stored for the driver profile currently used.

Depending on the light conditions, the brightness settings may not be clearly visible.

Resetting the vehicle configuration

All individual settings can be reset to the factory settings when the drive-ready state is switched off.

Via iDrive:

1. "CAR".

2. "Settings".

3. "General settings".

4. "Reset vehicle data".

5. "Reset vehicle data".

When the stored settings in a driver profile are synchronized with the ConnectedDrive account, these settings will remain in the ConnectedDrive account.

Speed warning
Concept A speed limit can be set that when reached will cause a warning to be issued. General information The warning is repeated if the vehicle speed exceeds the set speed limit again, after it has d ...

Personal settings
...

Other materials:

Diagnosis system
DESCRIPTION (a) When troubleshooting OBD II (On-Board Diagnostics) vehicles, an intelligent tester (complying with SAE J1987) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read. (b) OBD II regu ...

Refueling
Follow the following when refueling General information Follow the fuel recommendation prior to refueling. When refueling, insert the filler nozzle completely into the filler pipe. Lifting up the fuel pump nozzle during refueling causes: Premature switching off. Reduced return of the fuel vapors ...

Precaution
1. PRECAUTION OF HEADLIGHT BULB REPLACEMENT  When any defects such as deformation, crack, dent, chipping, etc. are identified on the discharge headlight (especially, on the light control ECU), replace it with a new one.  Even if the operation seems to be normal, the failsafe ...

В© 2011-2022 Copyright www.tsienna.net