Toyota RAV4 manuals

BMW 3 Series 2018-2022 Owners Manual: Adaptive light functions

BMW 3 Series 2018-2022 Owners Manual / Lights / Adaptive light functions

Concept

Adaptive light functions enable dynamic illumination of the roadway.

General information

The adaptive light functions may consist of one system or multiple systems, depending on the equipment version:

Activating

Press the button on the light switch element.

The LED in the button lights up.

The adaptive light functions are active when the drive-ready state is switched on.

Adaptive Light Control

General information

Depending on the steering angle and other parameters, the light from the headlight follows the course of the road.

To avoid blinding oncoming traffic, the Adaptive Light Control does not swivel to the opposite lane when the vehicle is at a standstill.

Cornering light

In tight curves, for instance on mountainous roads or when turning, an additional, cornering light is switched on that lights up the inside of the curve when the vehicle is moving below a certain speed.

The cornering light is automatically switched on depending on the steering angle or, where applicable, the use of turn signals.

When driving in reverse, the cornering lights may be automatically switched on regardless of the steering angle.

Adaptive headlight range control

The adaptive headlight range control feature balances out acceleration and braking processes as well as the vehicle load conditions in order to avoid dazzling oncoming traffic. Illumination of the road is optimized.

Welcome lights
General information Depending on the equipment, the exterior lighting of the vehicle can be set individually. Activating/deactivating Via iDrive: 1. "CAR". 2. "Settings". 3. "Exterior lighting". 4. ...

High-beam Assistant
Concept The high-beam Assistant detects other traffic participants early on and automatically switches the high beams on or off depending on the traffic situation. General information The high-beam As ...

Other materials:

Inspection
1. Inspect pack clearance of reverse clutch (A) install the intermediate shaft and needle roller bearing onto the transaxle rear cover. (B) using a dial indicator, measure the reverse clutch pack clearance while applying and releasing compressed air (392 kpa, 4.0 Kgf/cm2, 57 psi). Pack c ...

Eject Error/ Elevator Error/ Clamp Error
DTC 44-45 Eject Error DTC 44-51 Elevator Error DTC 44-52 Clamp Error DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-45 Disc cannot be ejected. Television display assembly 44-51 Mechanical error occurs during elevator operation. ...

For front passenger side
ON-VEHICLE INSPECTION 1. INSPECT AIR MIX CONTROL SERVO MOTOR (a) Remove the air mix control servo motor. (b) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the lever turns to "COOL" side smoothly. (c) Connect ...

В© 2011-2022 Copyright www.tsienna.net