Toyota RAV4 manuals

BMW 3 Series 2018-2022 Owners Manual: Changing/canceling the recognition function

BMW 3 Series 2018-2022 Owners Manual / Personal settings / Driver profiles / Changing/canceling the recognition function

If another vehicle key or another digital key is to be assigned to a driver profile, the current assignment must be canceled first.

Via iDrive:

1. "CAR".

2. "Driver profiles".

3. Move the Controller to the right.

As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.

4. "Driver recognition".

5. "with vehicle key"

or

"With Digital Key".

6. "Activate linkage"

If the vehicle and vehicle key will be handed over, e.g., for maintenance, the following steps must be carried out first:

The handed over vehicle key can then no longer be used to access the personal driver profile.

Selecting a driver profile

Depending on the recognition setting, the driver profile will be selected automatically.

If the guest profile is active, the driver profile will be selected on the Welcome screen or via iDrive: A PIN may have to be entered.

1. "CAR".

2. "Driver profiles".

As an alternative for Steps 1 and 2, the profile image can be tapped in the top status bar.

3. Select driver profile.

4. "OK".

All settings stored in the selected driver profile are automatically applied.

Switching synchronization with the ConnectedDrive account on/off

ConnectedDrive countries: The settings stored in the driver's profile are synchronized with the personal ConnectedDrive account. This means that it is possible to use the personal settings in other BMW vehicles with ConnectedDrive access as well, if this function is supported.

The synchronization with the ConnectedDrive account is enabled when a driver profile is created or via iDrive:

1. "CAR".

2. "Driver profiles".

3. Move the Controller to the right.

As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.

4. "Settings".

5. "Synchronize driver profile".

6. "Synchronize driver profile".

Creating a driver profile
A driver profile is created or via iDrive: 1. "CAR". 2. "Driver profiles". 3. Move the Controller to the right. As an alternative for Steps 1 to 3, the profile image can be tapped in the top status ...

Renaming a driver profile
Countries in which ConnectedDrive is not available: The name that was assigned when the driver profile was set up can be changed via iDrive: 1. "CAR". 2. "Driver profiles". As an alternative for Ste ...

Other materials:

Under hood
GENERAL MAINTENANCE 1. GENERAL NOTES Maintenance requirements very depending on the country. Check the maintenance schedule in the owner's manual supplement. Following the maintenance schedule is mandatory. Determine the appropriate time to service the vehicle using either miles dri ...

If you have a flat tire (vehicles with run-flat tires)
Your vehicle is not equipped with a spare tire, but instead you can continue driving the vehicle with run-flat tires even if any tire goes flat. In this case, slow down and drive with extra caution. Run-flat tires (A “RFT” or “DSST” mark is molded on the sidewall) Take your vehicle to ...

For rear air conditioning system
ON-VEHICLE INSPECTION 1. INSPECT REAR AIR MIX CONTROL SERVO MOTOR (a) Inspect servo motor operation. (1) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the arm turns to "HOT" side smoothly. (2) Connect the po ...

© 2011-2022 Copyright www.tsienna.net