Toyota RAV4 manuals

BMW 3 Series 2018-2022 Owners Manual: Cross traffic warning

Concept

At blind driveways or when driving out of diagonal parking spaces, approaching cross traffic is detected sooner by the system than is possible from the driver's seat.

General information

Driver assistance systems

Two radar sensors in the rear bumper monitor the area behind the vehicle.

The system indicates approaching traffic.

Depending on the vehicle equipment, the traffic area in front of the vehicle is monitored as well.

Two additional radar sensors are located in the front bumpers.

Safety information

Warning The system cannot serve as a substitute for the driver's personal judgment in assessing visibility and traffic situation. There is a risk of accident.

Adjust driving style to traffic conditions. Watch traffic closely and actively intervene where appropriate.

Overview

Button in the vehicle

Driver assistance systems

Park assistance button

Park assistance button

Driver assistance systems

The radar sensors are located in the rear bumper.

Driver assistance systems

Depending on the vehicle equipment, two additional radar sensors are located in the front bumpers.

Always keep the bumper in the area of the radar sensors clean and unobstructed.

Switching on/off

Activating/deactivating the system

1. Press the park assistance button.

2. Move the Controller to the right.

3. "Settings".

4. "Cross traffic warning".

5. "Cross traffic warning".

Or via iDrive:

1. "CAR".

2. "Settings".

3. "Driver Assistance".

4. "Parking and maneuvering".

5. "Cross traffic warning".

6. "Cross traffic warning".

Switching on automatically

If the system was activated on the Control Display, it is automatically switched on as soon as PDC Park Distance Control or Panorama View is active and a gear is engaged.

If reverse gear is engaged, the rear system is switched on.

Depending on the vehicle equipment, the front system is switched on when a forward gear is engaged.

Switching off automatically

The system is automatically switched off in the following situations:

Warning

General information

The respective display is called up on the Control Display. A signal tone may sound and the light in the exterior mirror may flash.

Light in the exterior mirror

Driver assistance systems

The light in the exterior mirror flashes if vehicles are detected by the rear sensors and your own vehicle is moving backwards.

Display in the PDC Park Distance Control view

Driver assistance systems

In the PDC Park Distance Control view, the respective boundary area flashes red, if vehicles are detected by the sensors.

Display in the camera view

Driver assistance systems

The respective boundary area, arrow 1, in the camera view flashes red, if vehicles are detected by the sensors.

Yellow lines, arrow 2, mark the bumper of your own vehicle.

Acoustic warning

In addition to the optical indicator, a warning signal sounds if your own vehicle moves into the respective direction.

System limits

The system may not be fully functional in the following situations:

System limits
Safety information Warning The system is designed to operate in certain conditions and circumstances. Due to conditions or other factors, the system may not respond. There may be a risk of accident ...

Driving comfort
Adaptive M chassis Concept The Adaptive M chassis is a controllable sport chassis/suspension. This system reduces undesirable vehicle motion when using a dynamic driving style or traveling on uneven r ...

Other materials:

Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING When exchanging the clips Remove the tape that remains on the mounting surface of the vehicle body and then clean the surface with white gasoline. Using a heat light, heat up the clip installation surfaces of the vehicle body and moulding. ...

Inspection
1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (w/o Memory)  Disconnect the mirror connector.  Check operation of the outer mirror. Apply battery voltage and inspect operation of the mirror face, as shown in the table and illustration. Standard (LH) If the result i ...

Idle Control System Malfunction
DESCRIPTION The idling speed is controlled by the ETCS (Electronic Throttle Control System). The ETCS is comprised of: 1) the one valve type throttle body; 2) the throttle actuator, which operates the throttle valve; 3) the Throttle Position (TP) sensor, which detects the opening angle of ...

В© 2011-2022 Copyright www.tsienna.net