Toyota RAV4 manuals

BMW 3 Series 2018-2022 Owners Manual: Jacking points for the vehicle jack

Wheels and tires

The jacking points for the vehicle jack are located at the indicated positions.

Jacking up the vehicle

Warning Hands and fingers can be jammed when using the vehicle jack. There is a risk of injury. Comply with the described hand position and do not change this position while using the vehicle jack.

1. Hold the vehicle jack with one hand, arrow 1, and grasp the vehicle jack crank or lever with your other hand, arrow 2.

Wheels and tires

2. Insert the vehicle jack into the rectangular recess of the jacking point closest to the wheel to be changed.

Wheels and tires

3. Extend the vehicle jack by turning the vehicle jack crank or lever clockwise.

Wheels and tires

4. Take your hand away from the vehicle jack as soon as the vehicle jack is under load and continue turning the vehicle jack crank or lever with one hand.

5. Make sure that the vehicle jack foot stands vertically and at a right angle beneath the jacking point.

Wheels and tires

6. Make sure that the vehicle jack foot stands vertically and perpendicularly beneath the jacking point after extending the vehicle jack.

Wheels and tires

7. Crank the vehicle up, until the vehicle jack is with the entire surface on the ground and the relevant wheel is maximum 1.2 inches/3 cm above ground.

Mounting a wheel

Mount one emergency wheel only, as required.

1. Unscrew the lug bolts.

2. Remove the wheel.

3. Put the new wheel or emergency wheel on and screw in at least two lug bolts in a crosswise pattern until hand-tight.

If non-original light-alloy wheels of the vehicle manufacturer are mounted, the accompanying lug bolts may have to be used as well.

4. Hand-tighten the remaining lug bolts and tighten all lug bolts well in a crosswise pattern.

5. Turn the vehicle jack crank counterclockwise to retract the vehicle jack and lower the vehicle.

6. Remove the vehicle jack and stow it securely.

After the wheel change

1. Tighten the lug bolts crosswise. The tightening torque is 101 lbs ft/140 Nm.

2. Stow the nonworking wheel in the cargo area, if necessary.

The nonworking wheel cannot be stored under the cargo floor panel because of its size.

3. Check tire inflation pressure at the next opportunity and correct as needed.

4. Reinitialize the Flat Tire Monitor.

Reset the Tire Pressure Monitor TPM.

5. Check to make sure the lug bolts are tight with a calibrated torque wrench.

6. Have the damaged tire replaced at the nearest dealer's service center or another qualified service center or repair shop.

Securing the vehicle against rolling
General information The vehicle manufacturer recommends to additionally secure the vehicle against rolling away when changing a wheel. On a level surface Place wheel chocks or other suitable objects ...

Emergency wheel
Concept In the event of a flat tire, the emergency wheel can be used in place of the wheel with the defective tire. The emergency wheel is only intended for temporary use until the defective tire/whe ...

Other materials:

Customizing vehicle features
Changing using the audio system screen Audio system with “CAR” button Press the “SETUP” button. Select “Vehicle” on the “Setup” screen. Audio system with “APPS” button Press the “APPS” button. Select “Setup” on the “Apps” screen and select ...

Brake fluid
Checking fluid level The brake fluid level should be between the “MAX” and “MIN” lines on the tank. “MAX” line “MIN” line Adding fluid Lift the cover off. Make sure to check the fluid type and prepare the necessary item. Brake fluid can absorb moisture from t ...

Operation check
1. CHECK WINDOW LOCK SWITCH  Check that the passenger side power window and slide door power window operation is disabled when the window lock switch of the power window master switch is pressed.  Check that the passenger side power window and slide door power windows can ...

© 2011-2022 Copyright www.tsienna.net