Toyota Sienna Service Manual: Removal
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE SLIDE DOOR
- Remove the rear door scuff plate (See page IR-7).
- Remove the back door scuff plate (See page ED-
214).
- Remove the quarter trim panel (See page IR-9).
- Remove the upper rail cushion from the rail.
- Disconnect the 2 connectors from the body side and
remove the bolt and wire.
- Open the quarter glass.
- Using a screwdriver, disengage the clip and 2 claws,
remove the rail end moulding.
HINT:
Tape the screwdriver tip before use.
- Remove the 2 bolts and bracket center No. 2
together with the tensioner (color: white).
- Remove the tensioner from the bracket center No.
2.
- Remove the 2 bolts and bracket center No. 1
together with the tensioner (color: black).
- Remove the tensioner from the bracket center No.
1.
- Remove the 2 nuts and open stop.
- Rotate the base of the slide door roller lower in the
direction indicated by arrow in the illustration and
then remove the roller from the cut area of the lower
rail from the body side.
- Move the slide door rearward and then remove the
slide door roller upper from the cut area in the rear
part of the slide door rail upper.
- Move the slide door further rearward and then
remove the slide door hinge center from the rear
part of the slide door rail center. Then, remove the
slide door.
2. REMOVE SLIDE DOOR RAILS
- Remove the roof headlining (See page IR-6).
- Remove the 2 bolts, 2 nuts and the rail upper.
- Remove the 2 screws and rear side rail.
- Remove the 3 screws and rail center
3. REMOVE SLIDE DOOR FULL OPEN STOP LOCK ASSEMBLY LH
- Disconnect the 2 cables.
- Remove the 2 bolts and full open stop lock.
4. REMOVE SLIDE DOOR ROLLER ASSEMBLY LOWER LH
- Remove the 3 bolts and roller.
5. REMOVE SLIDE DOOR HINGE ASSEMBLY CENTER LH
- Remove the 3 bolts and hinge.
- LH side:
Remove the cover.
6. REMOVE SLIDE DOOR ROLLER ASSEMBLY UPPER
- Remove the 2 bolts and roller.
1. REMOVE REAR DOOR WINDOW FRAME MOULDING
REAR LH (See page ET-31)
2. REMOVE REAR DOOR WINDOW FRAME MOULDING
SUB-ASSEMBLY LH (See page ET-32)
3. REMOVE SLIDE DOOR WINDOW GARNISH LH
Fully o ...
Other materials:
On-vehicle inspection
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT
INVOLVED IN COLLISION)
Perform a diagnostic system check.
2. INSPECT SEAT POSITION SENSOR (VEHICLE
INVOLVED IN COLLISION)
Perform a diagnostic system check.
Even if the airbag was not deployed, check if there
is any dama ...
Inspection
1. INSPECT REAR SPEED SENSOR
(a) Remove the seat cushion and seatback.
(b) Disconnect the speed sensor connector.
(c) Measure the resistance between terminals 1 and 2
of the speed sensor connector
OK:
Resistance:
1.1 +- 0.2 kΩ at 25 +- 5 °C
(d) Measure the resistance between ea ...
Power Back Door does not Operate
DESCRIPTION
The power back door operates only when the power back door main
switch is ON. The power back
door ECU controls the power back door by activating the back door motor
(built into the power back
door drive unit) to open / close the back door.
A request signal from the satell ...