Toyota Sienna Service Manual: Removal
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE SLIDE DOOR
- Remove the rear door scuff plate (See page IR-7).
- Remove the back door scuff plate (See page ED-
214).
- Remove the quarter trim panel (See page IR-9).
- Remove the upper rail cushion from the rail.
- Disconnect the 2 connectors from the body side and
remove the bolt and wire.
- Open the quarter glass.
- Using a screwdriver, disengage the clip and 2 claws,
remove the rail end moulding.
HINT:
Tape the screwdriver tip before use.
- Remove the 2 bolts and bracket center No. 2
together with the tensioner (color: white).
- Remove the tensioner from the bracket center No.
2.
- Remove the 2 bolts and bracket center No. 1
together with the tensioner (color: black).
- Remove the tensioner from the bracket center No.
1.
- Remove the 2 nuts and open stop.
- Rotate the base of the slide door roller lower in the
direction indicated by arrow in the illustration and
then remove the roller from the cut area of the lower
rail from the body side.
- Move the slide door rearward and then remove the
slide door roller upper from the cut area in the rear
part of the slide door rail upper.
- Move the slide door further rearward and then
remove the slide door hinge center from the rear
part of the slide door rail center. Then, remove the
slide door.
2. REMOVE SLIDE DOOR RAILS
- Remove the roof headlining (See page IR-6).
- Remove the 2 bolts, 2 nuts and the rail upper.
- Remove the 2 screws and rear side rail.
- Remove the 3 screws and rail center
3. REMOVE SLIDE DOOR FULL OPEN STOP LOCK ASSEMBLY LH
- Disconnect the 2 cables.
- Remove the 2 bolts and full open stop lock.
4. REMOVE SLIDE DOOR ROLLER ASSEMBLY LOWER LH
- Remove the 3 bolts and roller.
5. REMOVE SLIDE DOOR HINGE ASSEMBLY CENTER LH
- Remove the 3 bolts and hinge.
- LH side:
Remove the cover.
6. REMOVE SLIDE DOOR ROLLER ASSEMBLY UPPER
- Remove the 2 bolts and roller.
1. REMOVE REAR DOOR WINDOW FRAME MOULDING
REAR LH (See page ET-31)
2. REMOVE REAR DOOR WINDOW FRAME MOULDING
SUB-ASSEMBLY LH (See page ET-32)
3. REMOVE SLIDE DOOR WINDOW GARNISH LH
Fully o ...
Other materials:
Vehicle Speed Signal Circuit between Radio Receiver and Combination
Meter
DESCRIPTION
This circuit is necessary for the ASL (Auto Sound Leveliser) built into the
radio receiver.
Speed signals are received from the combination meter and used for the ASL.
The ASL function automatically adjusts the sound data in order to enable hearing
the clear audio sound
even ...
Random / Multiple Cylinder Misfire Detected
DESCRIPTION
When the engine misfires, high concentrations of hydrocarbons (HC) enter the
exhaust gas. High HC
concentration levels can cause increase in exhaust emission levels. Extremely
high concentrations of HC
can also cause increases in the Three-Way Catalytic Converter (TWC) tem ...
System description
1. DESCRIPTION OF OCCUPANT CLASSIFICATION SYSTEM
GENERAL DESCRIPTION.
In the occupant classification system, the
occupant classification ECU calculates the
weight of the occupant based on a signal from
the occupant classification sensors. This system
recognizes the occu ...