Toyota Sienna Service Manual: Removal
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE SLIDE DOOR
- Remove the rear door scuff plate (See page IR-7).
- Remove the back door scuff plate (See page ED-
214).
- Remove the quarter trim panel (See page IR-9).
- Remove the upper rail cushion from the rail.
- Disconnect the 2 connectors from the body side and
remove the bolt and wire.
- Open the quarter glass.
- Using a screwdriver, disengage the clip and 2 claws,
remove the rail end moulding.
HINT:
Tape the screwdriver tip before use.
- Remove the 2 bolts and bracket center No. 2
together with the tensioner (color: white).
- Remove the tensioner from the bracket center No.
2.
- Remove the 2 bolts and bracket center No. 1
together with the tensioner (color: black).
- Remove the tensioner from the bracket center No.
1.
- Remove the 2 nuts and open stop.
- Rotate the base of the slide door roller lower in the
direction indicated by arrow in the illustration and
then remove the roller from the cut area of the lower
rail from the body side.
- Move the slide door rearward and then remove the
slide door roller upper from the cut area in the rear
part of the slide door rail upper.
- Move the slide door further rearward and then
remove the slide door hinge center from the rear
part of the slide door rail center. Then, remove the
slide door.
2. REMOVE SLIDE DOOR RAILS
- Remove the roof headlining (See page IR-6).
- Remove the 2 bolts, 2 nuts and the rail upper.
- Remove the 2 screws and rear side rail.
- Remove the 3 screws and rail center
3. REMOVE SLIDE DOOR FULL OPEN STOP LOCK ASSEMBLY LH
- Disconnect the 2 cables.
- Remove the 2 bolts and full open stop lock.
4. REMOVE SLIDE DOOR ROLLER ASSEMBLY LOWER LH
- Remove the 3 bolts and roller.
5. REMOVE SLIDE DOOR HINGE ASSEMBLY CENTER LH
- Remove the 3 bolts and hinge.
- LH side:
Remove the cover.
6. REMOVE SLIDE DOOR ROLLER ASSEMBLY UPPER
- Remove the 2 bolts and roller.
1. REMOVE REAR DOOR WINDOW FRAME MOULDING
REAR LH (See page ET-31)
2. REMOVE REAR DOOR WINDOW FRAME MOULDING
SUB-ASSEMBLY LH (See page ET-32)
3. REMOVE SLIDE DOOR WINDOW GARNISH LH
Fully o ...
Other materials:
Noise Occurs
INSPECTION PROCEDURE
1 NOISE CONDITION
Check in which direction the noise comes from (front left
or right, or rear left or right).
Check in which direction the noise comes from.
OK:
The location of the noise source can be
determined
2 CHECK SPEAKERS
Check the installatio ...
Air Mix Damper Position Sensor Circuit (Driver Side)
DESCRIPTION
This sensor detects the position of the air mix control servo motor (air
outlet damper) and sends the
appropriate signals to the A/C amplifier. The position sensor is built in the
air mix control servo motor. The
position sensor resistance changes as the air mix control servo ...
ECM / PCM Internal Engine Off Timer Performance
DTC P2610 ECM / PCM Internal Engine Off Timer Performance
DTC SUMMARY
DESCRIPTION
To ensure the accuracy of the EVAP (Evaporative Emission) monitor values, the
soak timer, which is built
into the ECM, measures 5 hours (+/- 15 minutes) from when the ignition switch is
turned off, before t ...