Toyota RAV4 manuals

BMW 3 Series 2018-2022 Owners Manual: Resetting BMW Digital Key

To reset BMW Digital Key, an authorized vehicle key must be located in the vehicle.

After the reset, the vehicle can no longer be unlocked, locked or started with a digital key.

The vehicle owner must present proof of authorization for his vehicle again at the service center to be able to use BMW Digital Key again.

Via iDrive:

1. "CAR".

2. "Settings".

3. "Doors/Access".

4. "BMW Digital Key".

5. "Reset function".

Unlocking and locking the vehicle

Opening and closing

Hold the smartphone or key card directly on the outside door handle of the driver's door.

Starting the engine

Opening and closing

1. Open the cover of the smartphone tray.

2. Place the smartphone or key card centered into the smartphone tray in front of the cup holders.

3. After the digital key has been detected as authorized, the engine can be started.

Sale of the smartphone/vehicle

When a smartphone with a digital key is sold, all digital keys should be deleted from this smartphone.

When a vehicle is sold, BMW Digital Key should be reset in this vehicle. The new vehicle owner should make sure that BMW Digital Key has been reset. This ensures that the previous vehicle owner no longer has access to the vehicle.

Malfunction

Vehicle key recognition by the vehicle may malfunction under the following circumstances:

Transferring digital keys
The vehicle owner can transfer a digital key for his/her vehicle to another person with a compatible smartphone via the BMW Connected app. When a digital key is transferred, a transaction number TAN ...

Trunk lid
General information To avoid locking the vehicle key in the vehicle, do not place the remote control in the cargo area. Depending on the vehicle equipment and country version, it is also possible to ...

Other materials:

Installation
1. INSTALL REAR DOOR GLASS WEATHERSTRIP Install the rear door glass weatherstrip. 2. INSTALL SLIDE DOOR WINDOW ASSEMBLY 3. INSTALL REAR DOOR GLASS RUN 4. INSTALL REAR DOOR TRIM BOARD SUBASSEMBLY 5. INSTALL SIDE TRIM BOARD COVER REAR 6. INSTALL REAR DOOR WINDOW FRAME SUBASSEMBLY 7. INSTA ...

Precaution
1. INITIALIZATION NOTICE:  Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.  Perform REGISTRATION (VIN registration) when replacing the ECM. HINT: Initialization cannot be completed by only removing the batt ...

Removal
1. REMOVE OUTSIDE MOULDING Put protective tape around the outside moulding. Using a heat light, heat the moulding between 40 to 60 C (104 to 140 F). NOTICE: Do not heat the moulding excessively. Tie both piano wire ends to a wooden block or a similar object. Cut off the tape by ...

В© 2011-2022 Copyright www.tsienna.net