Toyota RAV4 manuals

BMW 3 Series 2018-2022 Owners Manual: Setup assistant

The setup assistant is offered in new vehicles for a limited period of time on the Welcome screen to configure the most important settings for the vehicle.

"Getting started" Select to start the set-up assistant.

The set-up assistant can be started via iDrive at any time.

1. "CAR".

2. "Settings".

3. "General settings".

4. "Getting started".

The driver is guided step by step through the following functions:

The selected settings are stored in the active driver's profile.

Guest profile

The guest profile can be activated by any driver.

Vehicle settings that are entered when the guest profile is active will be stored in the guest profile.

In the following cases the guest profile is automatically active:

The following limitations apply:

The guest profile is selected on the Welcome screen or via iDrive:

1. "CAR".

2. "Driver profiles".

As an alternative for Steps 1 and 2, the profile image can be tapped in the top status bar.

3. "Guest".

4. "OK".

Concept, General information
Concept Driver profiles can be created to store personal vehicle settings. If the vehicle is used by multiple drivers, each driver can create his personal driver profile. When a driver profile is sele ...

Creating a driver profile
A driver profile is created or via iDrive: 1. "CAR". 2. "Driver profiles". 3. Move the Controller to the right. As an alternative for Steps 1 to 3, the profile image can be tapped in the top status ...

Other materials:

Mass or Volume Air Flow Circuit Range / Performance Problem
DTC P0101 Mass or Volume Air Flow Circuit Range / Performance Problem DESCRIPTION Refer to DTC P0100 DTC No. DTC Detection Condition Trouble Area P0101 High voltage: Conditions (a), (b) and (c) continue for more than 10 seconds (2 trip de ...

Disassembly
1. REMOVE CYLINDER BOOT (a) Using a screwdriver, remove the set ring and cylinder boot. 2. REMOVE REAR DISC BRAKE PISTON (a) Place a shop rug, between the rear disc brake piston and the disc brake cylinder. (b) Use compressed air to remove the rear disc brake piston from the disc brak ...

The Blind Spot Monitor function detection areas
The areas that vehicles can be detected in are outlined below. The range of the detection area extends to: Approximately 11.5 ft. (3.5 m) from the side of the vehicle The first 1.6 ft. (0.5 m) from the side of the vehicle is not in the detection area Approximately 9.8 ft. (3 m) ...

В© 2011-2022 Copyright www.tsienna.net