BMW 3 Series 2018-2022 Owners Manual: Wiper system
Switching the wipers on/off and brief wipe
Switching on
Press the lever up until the desired position is reached.
- Resting position of the wipers: position 0.
- Rain sensor: position 1.
- Normal wiper speed: position 2.
- Fast wiper speed: position 3.
Brief wipe and switching off
Press the lever down.
- Switching off: press the lever down until it reaches its standard position.
- Brief wipe: press the lever down from the standard position.
Rain sensor
Activating/deactivating
To activate: press the lever up once from its standard position, arrow 1.
To deactivate: press the lever back into the standard position.
Adjusting the sensitivity
Turn the thumbwheel on the wiper lever.
Cleaning the windshield
Pull the wiper lever towards you.
High beams, headlight flasher,
turn signal
High beams, headlight flasher
Push the lever forward or pull it backward.
High beams on, arrow 1.
The high beams light up when the low beams
are switched on.
High beams off/headlight flasher, ar ...
Climate control
Automatic climate control
Temperature.
Recirculated-air mode.
Maximum cooling.
AUTO program.
Air distribution, manual.
Switching off.
Defrost and defog the
windshield.
Rear window defroster.
...
Other materials:
Installation
1. INSTALL FRONT BUMPER ASSEMBLY
Push the front bumper onto the front of the vehicle
and engage the claws on the left and right sides of
the front bumper to install it as shown in the
illustration.
HINT:
Apply protective tape to the bottom part of the
front fender to prevent i ...
On-vehicle inspection
1. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE
NOT INVOLVED IN COLLISION)
Perform a diagnostic system check.
With the front seat side airbag assembly installed on
the vehicle, perform a visual check. If there are any
defects as mentioned below, replace the front
seatback as ...
Manual Up / Down Function does not Operate on Rear RH Only
DESCRIPTION
If the manual UP/DOWN function does not operate, the power window motor, the
regulator switch or the
wire harness may be malfunctioning.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK WIRE HARNESS (POWER SOURCE)
Disconnect the P39 regulator switch connector.
Turn ...
