Toyota Sienna Service Manual: 2Gr-fe emission control
- Emission control system
- Canister
- Vacuum switching valve
- Ventilation valve
- Air fuel ratio sensor (for 2wd)
- Air fuel ratio sensor (for 4wd)
- Heated oxygen sensor (for 2wd)
- Inspection
- Heated oxygen sensor (for 4wd)
- Fuel tank cap
Fuel tank
Components
REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
(See page FU-1)
2. REMOVE CHARCOAL CANISTER PROTECTOR (See
page FU-30)
3. REMOVE REAR FLOOR NO. 2 CROSSMEMBER BRACE LH
(a) Remov ...
Other materials:
Air Outlet Damper Position Sensor Circuit
DESCRIPTION
This sensor detects the position of the air outlet control servo motor and
sends the appropriate signals to
the A/C amplifier. The position sensor is built in the air outlet control servo
motor. The position sensor's
resistance changes as the air outlet control servo motor arm ...
Problem symptoms table
HINT:
Proceed to the troubleshooting for each circuit in the table
below.
Occupant Classification System
Symptom
Suspected area
The front passenger seat condition differs from the
indication by the passenger airbag ON/OFF indicator
(DTC is not output).
Trouble ...
Installation
1. INSTALL THROTTLE BODY
Install a new throttle body gasket to the intake air
surge tank.
Install the throttle body with the 4 bolts.
Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Connect the 2 water by-pass hoses.
Connect the throttle body connector and clamp.
2. ...
