Toyota Sienna Service Manual: 2GR-FE Engine control system
- SFI system
- Precaution
- Definition of terms
- How to proceed with troubleshooting
- Check for intermittent problems
- Basic inspection
- Registration
- Checking monitor status
- Readiness monitor drive pattern
- Problem symptoms table
- Terminals of ECM
- Diagnosis system
- DTC check / clear
- Freeze frame data
- Check mode procedure
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
- Camshaft timing oil control valve assembly
- Throttle body
- ECM
- Accelerator pedal rod
- Mass air flow meter
- VVT sensor
- Engine coolant temperature sensor
- Knock sensor
- EFI relay
- Circuit opening relay
- Air fuel ratio sensor relay
Inspection
1. INSPECT GARAGE DOOR OPENER
Press the switch and check that each red LED turns
on. If one or more of the switches does not turn on
the LED, confirm normal operation of the fuse and ...
SFI system
...
Other materials:
USE SIMULATION METHOD TO CHECK
DTC B0113/42 Short to B+ in Side Squib RH Circuit
DESCRIPTION
The side squib RH circuit consists of the center airbag sensor assembly and
the front seat side airbag
assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0113/42 is recorded when a sh ...
Setting the vehicle speed (vehicle-to-vehicle distance control
mode)
Press the “ON-OFF” button to
activate the cruise control.
Dynamic radar cruise control indicator
will be displayed.
Press the button again to deactivate
the cruise control.
Accelerate or decelerate the
vehicle to the desired speed,
and push the lever down to set
...
Inspection
1. INSPECT SPEED SENSOR (NT SENSOR)
(a) Disconnect the speed sensor connector from the
transaxle.
(b) Measure the resistance according to the value(s) in
the table below.
AISIN made:
TOYOTA made:
2. INSPECT SPEED SENSOR (NC SENSOR)
(a) Disconnect the speed sensor connector from ...
