Toyota Sienna Service Manual: 2Gr-fe fuel

Reassembly

1. INSTALL STRAIGHT PIN (a) Using a plastic hammer, tap in new straight pins to the cylinder block. Standard protrusion 2. INSTALL STUD BOLT (a) Using E8 and E10 "TORX" sockets, i ...

Fuel system

...

Other materials:

DTC check / clear
NOTICE: All the stored DTCs and freeze frame data are erased if:  the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and fr ...

Installation
1. TEMPORARILY TIGHTEN AIR CONDITIONING UNIT ASSEMBLY (a) Engage the 2 claws. (b) Temporarily tighten the air conditioning unit assembly with the nut. Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 2. INSTALL LOWER DEFROSTER NOZZLE ASSEMBLY (a) Engage the 4 claws and install the lower defr ...

Disassembly
1. REMOVE FRONT DIFFERENTIAL RING GEAR (a) Place matchmarks on the front differential ring gear and differential case. (b) Remove the 14 bolts. (c) Using a plastic hammer, tap on the front differential ring gear to remove it from the case. 2. REMOVE FRONT DIFFERENTIAL CASE FRONT TA ...