Toyota Sienna Service Manual: 2Gr-fe lubrication

Installation

1. Connect inlet sub-assembly (a) Connect the inlet hose to the radiator. (b) Install the inlet sub-assembly to the radiator with the bolt. Torque: 7.1 N*m (72 kgf*cm, 63 in.*lbf)V 2. Ins ...

Lubrication system

On-vehicle inspection 1. CHECK ENGINE OIL LEVEL (a) Warm up the engine, stop it and wait 5 minutes. The oil level should be between the dipstick's low level mark and full level mark. If the eng ...

Other materials:

Reassembly
1. INSTALL REAR DOOR WIRE SUB-ASSEMBLY LH Install the wire. NOTICE: When installing the wire, push the areas where the clips are installed in order to prevent damage and deformation. Install the 2 screws 2. INSTALL REAR DOOR LOCK ASSEMBLY LH Apply MP grease to the slidin ...

Inspection
1. INSPECT RUNOUT OF DIFFERENTIAL RING GEAR (a) Using a dial gauge , check the runout of the ring gear. Maximum runout: 0.07 mm (0.0028 in.) If the runout is greater than the maximum, replace the ring gear with a new one. 2. INSPECT DIFFERENTIAL RING GEAR BACKLASH (a) Using a dial gauge, ...

High Temperature
DTC 44-47 High Temperature DESCRIPTION DTC No. DTC Detection Condition Trouble Area 44-47 Sensor detects that DVD unit temperature is high (Over 80C). Television display assembly INSPECTION PROCEDURE HINT: After the inspection is completed, cl ...