Toyota Sienna Service Manual: A/C ECU Communication Stop
DTC B1262 A/C ECU Communication Stop
DESCRIPTION
DTC B1262 is output when communication between the A/C amplifier and the multiplex network gateway ECU stops for more than 10 seconds.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
B1262 |
A/C ECU communication stops |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY)
- Disconnect the A9 connector.
- Measure the voltage according to the value(s) in the table below.
Standard voltage
HINT:
*1: for Automatic A/C
*2: for Manual A/C
2 CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard resistance
HINT:
*1: for Automatic A/C
*2: for Manual A/C
3 CHECK COMMUNICATION LINE
- Disconnect the C10 and A21 connectors.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
HINT:
*1: for Automatic A/C
*2: for Manual A/C
Result
REPLACE A/C AMPLIFIER
Rear Door ECU LH Communication Stop
DTC B1217 Rear Door ECU LH Communication Stop
DESCRIPTION
DTC B1217 is output when communication between the power slide door ECU LH
and the multiplex
network gateway ECU stops for more than 10 s ...
Combination Meter ECU Communication Stop
DTC B1271 Combination Meter ECU Communication Stop
DESCRIPTION
DTC B1271 is output when communication between the combination meter and the
multiplex network
gateway ECU stops for more than 10 se ...
Other materials:
Receiving a message
When an e-mail/SMS/MMS is received, the incoming message screen
pops up with sound and is ready to be operated on the screen.
Select to check the message.
Select to refuse the message.
Select to call the message
sender.
Receiving a message
Depending on the cellular phone used f ...
Сamshaft timing oil control valve assembly
COMPONENTS
ON-VEHICLE INSPECTION
1. INSPECT CAMSHAFT TIMING CONTROL VALVE ASSEMBLY
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch to the ON position.
(c) Start the engine and warm it up.
(d) Select the intelligent tester from the ACTIVE TEST
...
DTC check / clear
1. DTC CHECK
HINT:
When DTC B1150/23 is detected as a result of
troubleshooting for "Airbag System", perform
troubleshooting for the Occupant Classification System.
Check the DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to t ...
