Toyota RAV4 manuals

Toyota Sienna Service Manual: Abbreviations used in manual

Toyota Sienna Service Manual / Introduction / Terms / Abbreviations used in manual

Abbreviations used in manual

Abbreviations used in manual

Abbreviations used in manual

Abbreviations used in manual

Abbreviations used in manual

Abbreviations used in manual

Terms
...

Glossary of sae and Toyota terms
This glossary lists all SAE-J1930 terms and abbreviations used in this manual in compliance with SAE recommendations, as well as their TOYOTA equivalents. ...

Other materials:

Basic inspection
(a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS (1) Unless otherwise stated, all resistance measurements should be made at an ambient temperature of 20°C (68°F). Resistance measurements may be inaccurate if measured at high temperatures, i.e. immediately after the vehicle has been running ...

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE REAR NO. 2 SEAT LEG SIDE GARNISH SUB-ASSEMBLY  Disengage the 9 clips and remove the rear No. 2 seat leg side garnish sub-assembly.  Remove the 9 clips from the rear No. 2 seat leg side garnish sub-assembly. 3. ...

Installation
1. INSTALL FRONT SEAT ASSEMBLY LH  Place the seat assembly in the cabin. NOTICE: Be careful not to damage the body.  Connect the connectors under the seat assembly.  Tighten the 2 bolts on the front side of the seat assembly. Torque: 37 N*m (375 kgf*cm, 27 ft.*lb ...

© 2011-2025 Copyright www.tsienna.net