Toyota Sienna Service Manual: Accelerator pedal rod

Installation

1. INSTALL ECM  Install the ECM with the 2 nuts. Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)  Connect the 5 ECM connectors. 2. INSTALL ECM (with 10 speakers system)   ...

On-vehicle inspection

1. CHECK ACCELERATOR PEDAL ROD  Check the voltage.  Connect the intelligent tester to the DLC3.  Turn the ignition switch to the ON position. Turn the intelligent test ...

Other materials:

Installation
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) (See page EC-39) 2. INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Install a new gasket to the front exhaust pipe assembly. (b) Install the front exhaust pipe assembly with the 2 nuts. Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf) 3. V V(A) ins ...

Reassembly
1. Install lower radiator tank (a) After checking that there are no foreign objects in the lock plate groove, install a new O-ring without twisting it. HINT: When cleaning the lock plate groove, lightly rub it with sandpaper without scratching it. (b) Tap the lock plate with a plastic ...

Short in Driver Side Squib 2nd Step Circuit
DTC B1180/17 Short in Driver Side Squib 2nd Step Circuit DESCRIPTION The driver side squib 2nd step circuit consists of the center airbag sensor assembly, the spiral cable and the steering pad. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1180/17 is rec ...