(A) select the following menus on the intelligent tester: diagnosis, enhanced obdii, monitor info and monitor result. The monitor status appears after the component name.
(b) Confirm that the component is either PASS or FAIL.
(c) Select the component and press ENTER. The accuracy test value appears if the monitor status is either PASS or FAIL.
HINT:
The monitor result might be PASS on rare occasions even if the Malfunction Indicator Lamp (MIL) is illuminated. This indicates that the system was malfunctioning in the previous driving cycle.
This might be caused by an intermittent problem.
Installation
HINT:
Install the RH side by the same procedure as the LH side.
1. INSTALL FRONT DISC BRAKE CYLINDER SLIDE BUSH
(a) Apply the lithium soap base glycol grease to a new
front disc brake cylinder slide bush.
(b) Install the cylinder slide bush to the bottom side of
the front disc brake cyli ...
Outer mirror switch
Inspection
1. INSPECT OUTER MIRROR SWITCH ASSEMBLY (w/o
Memory)
The L side of the left / right adjustment switch:
Inspect the mirror switch resistance.
Standard resistance (Left side)
If the result is not as specified, replace the switch
assembly.
The R side of t ...
Disassembly
1. Remove park/neutral position switch assembly
(A) remove the nut, washer and control shaft lever.
(B) using a screwdriver, unstake the nut stopper, and
remove the lock nut and nut stopper.
(c) Remove the 2 bolts and pull out the park/neutral
position switch.
2. REMOVE BREATHER PLUG H ...