Toyota Sienna Service Manual: Active test

Toyota Sienna Service Manual / Engine / 2Gr-fe engine control system / Sfi system / Data list / active test / Active test

HINT:

Performing an ACTIVE TEST enables components including the relays, VSV (Vacuum Switching Valve), and actuators, to be operated without removing any parts.

The ACTIVE TEST can be performed with an intelligent tester. Performing an ACTIVE TEST in the first step in troubleshooting is one method to shorten diagnostic time.

DATA LIST can be displayed during ACTIVE TESTs.

(a) Connect an intelligent tester to the DLC3.

(b) Start the engine.

(d) Select the following menu items: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST.

(e) Perform the ACTIVE TEST by referring to the table below.

Active test

NOTICE:

*1: If the display of the DATA LIST's CAT OT MF F/C item is NOT AVL, perform this ACTIVE TEST with the vehicle stopped and the engine idling.
*1: If the display of the DATA LIST's CAT OT MF F/C item is AVAIL, perform this ACTIVE TEST as described below.

(a)Stop the engine and turn the ignition switch ON to turn FUEL CUT#1 (to #6) ON.

(b)Start the engine.

Data list

HINT: Reading the DATA LIST displayed on an intelligent tester enables values, including those of the switches, sensors, and actuators, to be checked without removing any parts. Reading the DATA L ...

System check

HINT: Performing a SYSTEM CHECK enables the system, which consists of the multiple actuators, to be operated without removing any parts. In addition, it can show whether or not any DTCs are set, a ...

Other materials:

Reassembly
1. INSTALL BACK DOOR STOPPER LOWER Install the 2 stoppers with the 4 bolts. Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf) 2. INSTALL BACK DOOR BASE STOPPER BRACKET Install the 2 stopper brackets with the 4 bolts. Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf) 3. INSTALL BACK DOOR LOCK ASSEMBLY ...

Inspection
1. INSPECT SPEED SENSOR (NT SENSOR) (a) Disconnect the speed sensor connector from the transaxle. (b) Measure the resistance according to the value(s) in the table below. AISIN made: TOYOTA made: 2. INSPECT SPEED SENSOR (NC SENSOR) (a) Disconnect the speed sensor connector from ...

Cursor or Map Rotates when Vehicle Stopped
INSPECTION PROCEDURE 1 CHECK CONDITION Check with the customer if the vehicle has been turned by a turntable. OK: Vehicle has not been turned by turntable. HINT: If the vehicle is turned on a turntable with the ignition switch on, the system may store the angular velocity. As a ...