Toyota RAV4 manuals

Toyota Sienna Service Manual: Actuator check

1. ACTUATOR CHECK

ACTUATOR CHECK

(a) After entering the DTC check mode (Sensor Check Mode), press the R/F switch.

(b) As each damper, motor and relay automatically operate actuator check at 1-second intervals from step No. 1 to No. 10 continuously, check the temperature and air flow visually and by hand.

If the slower display is desired, press the DEF switch and change it to step operation. Each time the DEF switch is pressed, the display changes by 1 step.

HINT:

ACTUATOR CHECK

Diagnostic trouble code chart
If a trouble code is displayed during the DTCs check (sensor check), check the circuit listed for the code in the table below (Proceed to the page given for that circuit). AIR CONDITIONING SYSTEM ...

Room Temperature Sensor Circuit
DESCRIPTION This sensor detects the cabin temperature that is used as the basis for temperature control and sends a signal to the A/C amplifier. WIRING DIAGRAM INSPECTION PROCEDURE 1 READ VAL ...

Other materials:

On-vehicle inspection
1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check.  With the front passenger airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the instrumen ...

Rear Door ECU LH Communication Stop
DTC B1217 Rear Door ECU LH Communication Stop DESCRIPTION DTC B1217 is output when communication between the power slide door ECU LH and the multiplex network gateway ECU stops for more than 10 seconds. DTC No. DTC Detection Condition Trouble Area B1217 ...

Data list / active test
1. READ DATA LIST HINT: Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be disco ...

В© 2011-2025 Copyright www.tsienna.net