Toyota Sienna Service Manual: Adjustment
HINT:
- On the RH side, use the same procedures as on the LH side.
- Since a centering bolt is used as a door hinge mounting bolt on the body side and the door side, the door can not be adjusted with it on. Substitute a bolt with a washer for the centering bolt.
1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH
- Check that the clearance is within the standard range.
Standard
2. ADJUST FRONT DOOR PANEL SUB-ASSEMBLY LH
- Using SST, horizontally and vertically adjust the
door by loosening the body side hinge bolts.
SST 09812-00010, 09812-00020
- Tighten the door side hinge bolts after the
adjustment.
Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
- Adjust the door forward / rearward and vertically by loosening the door side hinge bolts.
- Tighten the door side hinge bolts after the
adjustment.
Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
- Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
- Tighten the striker mounting screws after the
adjustment.
Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)
Disassembly
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
Using a screwdriver, disengage the clip and claw,
and remove the garnis ...
Reassembly
1. INSTALL FRONT DOOR WIRE LH
Install the wire with the 2 bolts.
Torque: Reference
8.0 N*m (82 kgf*cm, 71 in.*lbf)
NOTICE:
In order to prevent water leakage, be sure that
the lip of t ...
Other materials:
Listening to a
USB memory device
Connecting a USB memory device enables you to enjoy music
from the vehicle speakers.
Touch “USB” on the audio source selection screen.
Connecting a USB memory device
Audio control screen
Pressing the “AUDIO” button displays the audio control screen from
any screens of the selected so ...
Automatic transaxle fluid
On-vehicle inspection
1. CHECK FLUID LEVEL
HINT:
Drive the vehicle so that the engine and transaxle are at
normal operating temperature.
Fluid temperature:
70 to 80°C (158 to 176°F)
(a) Park the vehicle on a level surface and set the
parking brake.
(b) With the engine idling and the ...
Inspection
1. Inspect starter assembly
NOTICE:
These tests must be performed within 3 to 5 seconds
to avoid burning out the coil.
(a) Perform the pull-in test.
(1) Disconnect the lead wire from terminal C.
(2) Connect the battery to the magnetic switch as
shown in the illustratio ...
