Adjusting the temperature setting
Turn the “TEMP” dial clockwise to increase the temperature and counterclockwise to decrease the temperature.
The “SYNC” button
The air conditioning system switches between individual (indicator( s) off) and simultaneous (indicators on) modes.
When the air conditioning system is in simultaneous mode, the passenger and/or rear side temperature will be synchronized with driver side’s.
Press the “SYNC” button. (indicators on)
*: When the rear air conditioning system is on.
The temperature for the driver, passenger and/or rear seats side can be adjusted separately.
When all indicators on the “SYNC” button are on:
When two indicators on the “SYNC” button are on:
If both the temperature of the passenger and rear seats side are changed, all indicators on the button will be off.
Adjusting the fan speed setting
Press “” on
to increase the fan speed and “”
to
decrease the fan speed.
Press to turn the fan off.
Change the airflow mode
To change the air outlets, press the “MODE” button.
The air outlets used are switched each time the button is pressed.
On-vehicle inspection
1. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE
NOT INVOLVED IN COLLISION)
Perform a diagnostic system check.
With the front seat side airbag assembly installed on
the vehicle, perform a visual check. If there are any
defects as mentioned below, replace the front
seatback as ...
Brake Switch "A" Circuit
DTC P0571 Brake Switch "A" Circuit
DESCRIPTION
When the brake pedal is depressed, the stop light switch sends a signal to
the ECM. When the ECM
receives this signal, it cancels the cruise control. The fail-safe function
operates to enable normal driving
even if there is a malfuncti ...
Removal
1. REMOVE OUTSIDE MOULDING
Put protective tape around the outside moulding.
Using a heat light, heat the moulding between 40 to
60 C (104 to 140 F).
NOTICE:
Do not heat the moulding excessively.
Tie both piano wire ends to a wooden block or a
similar object.
Cut off the tape by ...