Toyota Sienna Service Manual: Air fuel ratio sensor (for 4wd)

Installation

1. Install air fuel ratio sensor (for bank 2 sensor 1) (a) Using SST, install the sensor to the exhaust manifold LH. SST 09224-00010 Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST ...

On-vehicle inspection

HINT: The type of ignition switch on this model differs according to the specifications of the vehicle. For the expressions used in this section, refer to the "EXPRESSIONS OF IGNITION SWITCH& ...

Other materials:

Installation
1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY (a) Connect the connector. (b) Install the tire pressure warning receiver assembly with the bolt. Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 2. INSTALL ROOF HEADLINING ASSEMBLY HINT: Refer to the instructions for INSTALLATION of the ROOF ...

Improper Aiming of Radar Sensor Beam Axis
DTC P1572 Improper Aiming of Radar Sensor Beam Axis DESCRIPTION This DTC is output when the scanning angle of the laser sensor is incorrect. This DTC is also output when the laser sensor beam axis is determined to be in an incorrect position. DTC No. DTC Detection Condition ...

Diagnosis system
1. DESCRIPTION (a) When troubleshooting OBD II vehicles, the only difference from the usual troubleshooting procedure is to connect an OBD II scan tool complying with SAE J1987 or a intelligent tester to the vehicle, and read off various data output from the vehicle's ECM. (b) OBD II reg ...