ON-VEHICLE INSPECTION
1. INSPECT AIR OUTLET CONTROL SERVO MOTOR
(a) Remove the air outlet control servo motor.
(b) Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, then check that the lever turns to "DEF" position.
(c) Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 4, then check that the lever turns to "FACE" position.
NOTICE: While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.
If the operation is not as specified, replace the air outlet control servo motor.
Grocery bag hooks
The hooks are designed to hang things like a grocery bag.
Type A (front seatback)
(if equipped)
Type B (third seatback)
Type C (luggage compartment)
Type D (luggage compartment)
Pull the hook up.
WARNING
Type C: When not in use, keep the grocery ...
Suspension system
How to proceed with troubleshooting
HINT:
This is the repair procedure for vehicle pull.
Problem symptoms table
FRONT SUSPENSION SYSTEM
REAR SUSPENSION SYSTEM
...
Installation
1. INSTALL FRONT SHOULDER BELT ANCHOR
ADJUSTER ASSEMBLY
Install the front shoulder belt anchor adjuster
assembly with the bolt.
Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf)
2. INSTALL CENTER PILLAR UPPER GARNISH
3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
NOTICE:
Do not disassemble ...