DESCRIPTION
This sensor detects the position of the air outlet control servo motor and sends the appropriate signals to the A/C amplifier. The position sensor is built in the air outlet control servo motor. The position sensor's resistance changes as the air outlet control servo motor arm moves.
It outputs voltage (5 V) that is input to terminal 2 and terminal 3 via the variable resistor, and then to the A/ C amplifier. The A/C amplifier determines the arm position based on the input voltage from the position sensor.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 READ VALUE OF INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
(c) Select the items below in the DATA LIST, and read the displays on the intelligent tester.
DATA LIST / AIR CONDITIONER
OK: The display is as specified in the normal condition column.
Result
2 INSPECT AIR OUTLET CONTROL SERVO MOTOR
(a) Remove the air outlet control servo motor.
(b) Disconnect the connector from the air outlet control servo motor.
(c) Measure the resistance according to the value(s) in the table below
Standard resistance
(d) Measure the resistance according to the value(s) in the table below.
Standard resistance
(e) As the air outlet control servo motor moves from the FACE side to the DEF side, the resistance decreases gradually without interruption.
3 CHECK HARNESS AND CONNECTOR (AIR OUTLET CONTROL SERVO MOTOR - A/C AMPLIFIER)
(a) Disconnect the connector from the A/C amplifier.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance
REPLACE A/C AMPLIFIER
On-vehicle inspection
1. INSPECT COOLER CONDENSER CORE
(a) If the fin of the cooler condenser core is dirty, clean
it with water and dry it with compressed air.
NOTICE:
Do not damage the fin of the cooler condenser
core.
(b) If the fin of the cooler condenser core is bent, make
it straight using a screwdriver or p ...
Panel Switch Error/ Touch Switch Error
DTC 21-10 Panel Switch Error
DTC 21-11 Touch Switch Error
DTC 23-10 Panel Switch Error
DTC 23-11 Touch Switch Error
DTC 24-10 Panel Switch Error
DTC 24-11 Touch Switch Error
DTC 25-10 Panel Switch Error
DTC 25-11 Touch Switch Error
DESCRIPTION
INSPE ...
Short to GND in Curtain Shield Squib RH Circuit
DTC B1162/81 Short to GND in Curtain Shield Squib RH Circuit
DESCRIPTION
The curtain shield squib RH circuit consists of the center airbag sensor
assembly and the curtain shield
airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1162/81 is ...