Toyota RAV4 manuals

Toyota Sienna 2010-2022 Owners Manual: Air outlets

Location of air outlets

Toyota Sienna. Location of air outlets


The air outlets and air volume changes according to the selected air flow mode.

Adjusting the position of the air outlets

Direct air flow to the front or rear, up or down.

Toyota Sienna. Adjusting the position of the air outlets


Temperature display

The temperature display on the multi-information display can be changed.

When the front air conditioning system is in simultaneous mode

The lower side indicator on the “SYNC” button is on. The rear air conditioning system controls will continue to function.

NOTICE

To prevent battery discharge

Do not leave the air conditioning system on longer than necessary when the engine is stopped.

Using automatic mode
Press the “AUTO” button (“AUTO” appears on the display). Adjust the temperature setting. To stop the operation, press the “OFF” button. Automatic mode indicator If the fan speed ...

Heated steering wheel/seat heaters
Heated steering wheel and seat heaters heat the side grips of the steering wheel and seats, respectively. WARNING Care should be taken to prevent injury if anyone in the following ca ...

Other materials:

Power Window cannot be Operated by Wireless Operation
DESCRIPTION When the switch on the transmitter is operated during normal operating conditions, the multiplex network body ECU sends a request signal to the master switch and the regulator switches which then drive the applicable power window motors. INSPECTION PROCEDURE 1 CHECK WIRELESS DOO ...

Air Intake Control Circuit
DESCRIPTION The air cleaner is equipped with two inlets, one of which is opened or closed by the Air Intake Control Valve (AICV). This system reduces intake noise and increases engine power at low-to-high engine speed range. When the engine is operating in the low-to-mid speed range, this ...

ECU Power Source Circuit
DESCRIPTION This circuit provides power to operate the theft deterrent (warning) ECU. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT FUSE (ECU-B) Remove the ECU-B fuse from the engine room J/B. Measure the resistance. Standard resistance: Below 1 Ω 2 CHECK INSTRUMENT PANEL ...

© 2011-2022 Copyright www.tsienna.net