Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Audio system types

Owners of models equipped with a navigation system should refer to the “NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MANUAL�.

Using cellular phones

Interference may be heard through the audio system’s speakers if a cellular phone is being used inside or close to the vehicle while the audio system is operating.

NOTICE

To prevent battery discharge

Do not leave the audio system on longer than necessary when the engine is off.

To avoid damaging the audio system

Take care not to spill drinks or other fluids on the audio system.

Basic Operations
...

Audio system
Operations such as listening to audio, using the hands-free phone, confirming vehicle information and changing audio system settings are started by using the following buttons. ...

Other materials:

Short to GND in Side Squib LH Circuit
DTC B0117/45 Short to GND in Side Squib LH Circuit DESCRIPTION The side squib LH circuit consists of the center airbag sensor assembly and the front seat side airbag assembly LH. This circuit instructs the SRS to deploy when deployment conditions are met. DTC B0117/45 is recorded when a s ...

TC and CG Terminal Circuit
DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are displayed by the blinking pattern of the ABS warning light. WIRING DIAGRAM HINT: When warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ...

Installation
1. INSTALL NO.1 NAVIGATION BRACKET  Install the No.1 navigation bracket with the 4 screws. 2. INSTALL NO.2 NAVIGATION BRACKET  Install the No.2 navigation bracket with the 4 screws. 3. INSTALL INSTRUMENT CLUSTER FINISH PANEL UPPER  Install the instrum ...

© 2011-2026 Copyright www.tsienna.net