Toyota Sienna Service Manual: Audio terminal
COMPONENTS
REMOVAL
1. REMOVE INSTRUMENT CLUSTER CENTER NO. 2 FINISH PANEL
- Using a moulding remover, disengage the 3 clips.
- Disconnect the connector and remove the instrument cluster center No. 2 finish panel.
2. REMOVE STEREO JACK ADAPTER ASSEMBLY
- Disengage the claw and remove the stereo jack adapter assembly.
INSTALLATION
1. INSTALL STEREO JACK ADAPTER ASSEMBLY
- Engage the claw to install the stereo jack adapter assembly.
2. INSTALL INSTRUMENT CLUSTER CENTER NO. 2 FINISH PANEL
- Connect the connector
- Engage the 3 clips to install the instrument cluster center No. 2 finish panel.
Video terminal
COMPONENTS
REMOVAL
1. REMOVE REAR DOOR SCUFF PLATE LH
2. REMOVE REAR DOOR WEATHERSTRIP LH
3. REMOVE BACK DOOR WEATHERSTRIP
4. REMOVE BACK DOOR SCUFF PLATE
5. REMOVE QUARTER TRIM FRONT PANE ...
Steering pad switch
COMPONENTS
...
Other materials:
Seat belt warning system
PARTS LOCATION
Problem symptoms table
SEAT BELT WARNING SYSTEM
Symptom
Suspected Area
Driver side seat belt waning light does not operate
Fuse
Combination meter
Center airbag sensor assembly
Front seat inner belt assembly
Wire harness
...
Front Occupant Classification Sensor RH Circuit
Malfunction
DTC B1781 Front Occupant Classification Sensor RH Circuit
Malfunction
DESCRIPTION
The front occupant classification sensor RH circuit consists of the occupant
classification ECU and the
front occupant classification sensor RH.
DTC B1781 is recorded when a malfunction is detected in the fron ...
Data list / active test
1. USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Monitor the ECU data by following the prompts on
the tester screen.
HINT:
The intelligent tester has a "Snapshot" function
which records the monitored data. Refer to the
intelligent tester ope ...
