Toyota Sienna Service Manual: Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
DESCRIPTION
If AUTO UP operation does not fully close the power window, the following conditions may be the cause.
- The reset of the power window motor has not been completed, resulting in activation of the jam protection function.
- The memory of the power window switch misses the fully closed position of the power window, thus the window stops AUTO UP operation halfway.
- The jam protection function is activated at the fully closed position.
- Too much sliding resistance is applied to the window, resulting in activation of the jam protection function.
INSPECTION PROCEDURE
1 RESET POWER WINDOW REGULATOR MOTOR (DRIVER SIDE)
- Reset the power window regulator motor.
- Check if the power window operate normally.
2 CHECK POWER WINDOW REGULATOR W/ MOTOR (DRIVER SIDE)
- Remove the driver side door glass.
- Operate the power window regulator via the power window master switch without the door glass being installed.
- Check that the power window regulator operates smoothly.
REPLACE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
Power Window can be Operated After Ignition Switch is Turned OFF
Even if Operative Conditions are not Met
DESCRIPTION
The multiplex network body ECU controls power supplied to the power window
master switch and each
regulator switch continuously for 45 seconds after the ignition switch is turned
OFF ...
Power Window cannot be Operated by Wireless Operation
DESCRIPTION
When the switch on the transmitter is operated during normal operating
conditions, the
multiplex network body ECU sends a request signal to the master switch and the
regulator switch ...
Other materials:
Adjustment procedure
Hold the steering wheel and
push the lever down.
Adjust to the ideal position by
moving the steering wheel horizontally
and vertically.
After adjustment, pull the lever up
to secure the steering wheel.
...
Installation
1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the park/neutral position switch to the manual
valve shaft.
(b) Temporarily install the 2 bolts.
(c) Place a new lock plate and tighten the nut.
Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf)
(d) Temporarily install the control ...
Front Airbag Sensor RH Circuit Malfunction
DTC B1148/36 Front Airbag Sensor RH Circuit Malfunction
DESCRIPTION
The front airbag sensor RH circuit consists of the center airbag sensor
assembly and front airbag sensor
RH. If the center airbag sensor assembly receives signals from the front airbag
sensor RH, it judges
whether or not the ...
