Toyota RAV4 manuals

Toyota Sienna Service Manual: Automatic transaxle assembly

Components

Automatic transaxle assembly

Automatic transaxle assembly

Installation
1. INSTALL TRANSAXLE HOUSING OIL SEAL (a) Using SST and a hammer, install a new oil seal. SST 09316-60011 (09316-00011) Oil seal installation depth: -0.5 to 0.5 mm (-0.020 to 0.020 in.) (b) ...

Removal
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE HINT: (See page EM-26) 2. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH HINT: (See page DS-6) 3. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH HINT: (See page DS-6) 4. ...

Other materials:

Removal
HINT: Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds ...

Installation
1. INSTALL CHARCOAL CANISTER ASSEMBLY (a) Install the 3 bolts and charcoal canister. Torque: 29 N*m (296 kgf*cm, 21 ft.*lbf) (b) Connect the purge line hose to the charcoal canister. (c) Connect the wire harness clamp. (d) Connect the vapor pressure sensor connector. (e) Connect t ...

Body
GENERAL MAINTENANCE 1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY (a) Tighten all the parts of the chassis when necessary. Steering system Drive train Suspension Brake system Engine mounting, etc. (b) Tighten all the parts of the body when necessary. Seat belts Seats Doors ...

В© 2011-2024 Copyright www.tsienna.net