Toyota RAV4 manuals

Toyota Sienna Service Manual: Axle

Installation
1. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT BOLT (a) Install the bolt tightening the nut through the plate washer. 2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH HINT: (See page DS-26) 3. INSTALL ...

Axle system
PROBLEM SYMPTOMS TABLE Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of problem. Check each part in order. If necessary, rep ...

Other materials:

Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT)
SYSTEM DESCRIPTION The linear solenoid valve (SLT) controls the transmission line pressure for smooth transmission operation based on signals from the throttle position sensor and the vehicle speed sensor. The ECM adjusts the duty ratio (*) of the SLT solenoid valve to control hydraulic line ...

Half Connection in Center Airbag Sensor Assembly Connectors
DTC B1135/24 Half Connection in Center Airbag Sensor Assembly Connectors DESCRIPTION The center airbag sensor assembly connector has a mechanism that electrically detects half connection. The center airbag sensor assembly monitors the voltage applied to the disconnection detection pins and ...

Disassembly
1. REMOVE REAR DIFFERENTIAL CARRIER COVER (a) Remove the 8 bolts from the carrier cover. (b) Using a brass bar and a hammer, separate the carrier cover from rear differential carrier assembly. (c) Remove the breather plug from the rear differential carrier cover. (d) Remove the bol ...

В© 2011-2026 Copyright www.tsienna.net