Toyota Sienna Service Manual: Back Door Closer Switch Malfunction
DTC B2215 Back Door Closer Switch Malfunction
DESCRIPTION
This DTC is output when a malfunction occurs in the position switch in the back door. This position switch detects if the back door is in the latch position and sends a position signal to the power back door ECU.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
B2215 |
Back door does not operate |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
1 CHECK WIRE HARNESS (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR ECU)
- Disconnect the B10 lock and P13 ECU connectors.
- Check the resistance between the wire harness side connectors.
Resistance (Check for open circuit)
- Check the resistance between the B10 lock connector and body ground.
Resistance (Check for open circuit)
2 INSPECT BACK DOOR LOCK ASSEMBLY
- Check operation of the door lock.
- Using a screwdriver, push the latch in order to put the back door lock in the locked condition (full-latch position).
- Connect the battery positive (+) lead to terminal 1
and the battery negative (-) lead to terminal 2. Then,
check operation of the latch.
OK: The latch turns to the open-latch position
- Inspect motor operation when battery voltage is applied to the terminals.
OK
- Check the back door courtesy switch resistance.
- Check the resistance between the terminals of the courtesy switch.
Resistance
- Check the back door latch switch resistance.
- Check the resistance between the terminals of the latch switch.
Resistance
- Check the position switch resistance.
- Connect the battery positive (+) lead to connector terminal 1 and the negative (-) lead to connector terminal 2.
Resistance
REPLACE POWER BACK DOOR ECU
Diagnostic trouble code chart
If a malfunction code is displayed during the DTC check,
check the circuit listed for that code in the table below.
(Proceed to the page given for that circuit.)
BACK DOOR CLOSER SYSTEM
...
Back Door Closer does not Operate
DESCRIPTION
The power back door ECU controls the back door closer system. In response to
the signals output from
the switches related to the back door lock, the back door latch activates the
clo ...
Other materials:
Removal
1. REMOVE CENTER REAR SEAT LAP TYPE BELT
ASSEMBLY (for 8-Passenger)
HINT:
Refer to the instructions for disassembly of the rear No. 1 seat assembly (for
center seat).
Remove the bolt and center seat lap type belt
assembly.
2. REMOVE CENTER REAR NO. 2 SEAT LAP BELT
ASSEMBLY WITH ...
Removal
1. REMOVE BACK DOOR CENTER GARNISH (See page
ET-18)
2. REMOVE POWER BACK DOOR ROD (See page ED-
220)
3. REMOVE BACK DOOR LH SIDE GARNISH
4. REMOVE BACK DOOR RH SIDE GARNISH
5. REMOVE BACK DOOR PULL STRAP (See page ED-
221)
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
7. REMOVE LH BACK-UP LIGH ...
Cargo net hooks
Raise the hook to use.
Pattern 1
Pattern 2
NOTICE
To prevent damage to the cargo net hooks, avoid hanging things other
than
a cargo net on them.
Storage box (if equipped)
Engage the latch buckle. ...
