Toyota Sienna Service Manual: Bearing retainer oil seal

Transfer oil

ON-VEHICLE INSPECTION 1. INSPECT TRANSFER OIL (a) Remove the No. 1 plug and gasket. (b) Check the oil level is within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for No. 1 plug. ...

Removal

1. DRAIN AUTOMATIC TRANSAXLE FLUID (See page AX-131) 2. REMOVE NO. 1 TRANSFER CASE PLUG (See page TF-8) 3. REMOVE TRANSFER DRAIN PLUG (a) Remove the transfer drain plug, gasket and bleed the dra ...

Other materials:

Inspection
1. INSPECT CHARCOAL CANISTER ASSEMBLY (a) Visually check the charcoal canister for cracks or damage. If cracks or damage are found, replace the charcoal canister assembly. (b) Check charcoal canister operation. (1) With the purge port closed, blow 1.67 kPa (17.0 gf/cm2, 0.24 psi) ...

Screen Flicker or Color Distortion
INSPECTION PROCEDURE 1 CHECK DISPLAY SETTING Enter the display adjustment screen by pressing the "DISPLAY" switch.  Reset display settings (contrast, brightness) and check that the screen appears normal Press the "INFO" switch and then select "S ...

Rear Occupant Classification Sensor RH Circuit Malfunction
DTC B1783 Rear Occupant Classification Sensor RH Circuit Malfunction DESCRIPTION The rear occupant classification sensor RH circuit consists of the occupant classification ECU and the rear occupant classification sensor RH. DTC B1783 is recorded when a malfunction is detected in the rear oc ...