Toyota Sienna Service Manual: Blower unit

Installation

1. TEMPORARILY TIGHTEN AIR CONDITIONING UNIT ASSEMBLY (a) Engage the 2 claws. (b) Temporarily tighten the air conditioning unit assembly with the nut. Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf ...

Removal

1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY WITH PASSENGER AIRBAG ASSEMBLY HINT: Refer to the instructions for removal of the instrument panel sub-assembly w/ passenger airbag assembly (See page IP-5) ...

Other materials:

Throttle / Pedal Position Sensor / Switch "A/B" Circuit
DTC P0120 Throttle / Pedal Position Sensor / Switch "A" Circuit DTC P0122 Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input DTC P0123 Throttle / Pedal Position Sensor / Switch "A" Circuit High Input DTC P0220 Throttle / Pedal Position Sensor / Switch ...

Oxygen (A/F) Sensor Pumping Current Circuit
HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the Air-Fuel Ratio (A/F) sensor. Sensor 1 refers to the sensor mounted in front of the Three-Way Catalytic Converter (TWC) and located near the engine assembly. DESCRIPTION Refer to DTC P2195 (See page ES-355 ...

Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE FRONT BUMPER ASSEMBLY Remove the 4 screws and separate the fender liner from the front bumper assembly. Remove the 8 screws and separate the engine under cover from the front bumper assembly. Remove the 5 ...