GENERAL MAINTENANCE
1. INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Check the entire circumference and length of the brake hoses using a mirror as required in a well-lighted area.
Turn the front wheels fully right or left before checking the front brakes.
(a) Check all the brake lines and hoses for:
(b) Check all the clamps for tightness and connections for leakage.
(c) Check that the hoses and lines are clear of sharp edges, moving parts and the exhaust system.
(d) Check that the lines are installed in grommets passing through the center of the grommets.
2. INSPECT FRONT BRAKE PADS AND DISCS
HINT:
(See page BR-26)
(a) If a squealing or scraping noise is heard from the brakes while driving, check the pad wear indicator.
If there are traces of the indicator contacting
3. INSPECT REAR BRAKE PADS AND DISCS
HINT:
(See page BR-32)
4. REMOVE REAR BRAKE LININGS AND DRUMS
HINT:
(See page BR-39)
Rear wiper motor and bracket
COMPONENTS
REMOVAL
1. REMOVE REAR WIPER ARM
Remove the rear wiper arm head cap from the rear
wiper arm.
Remove the nut and the rear wiper arm.
2. REMOVE BACK DOOR GARNISH CENTER
3. REMOVE BACK DOOR SIDE GARNISH LH
4. REMOVE POWER BACK DOOR ROD
5. REMOVE BACK DOOR ...
How to proceed with troubleshooting
The intelligent tester can be used at step 2, 5, 8, 11.
1 Vehicle Brought to Workshop
2 Check and Clear DTCs and Freeze Frame Data
HINT:
See page BC-82 and BC-84.
3 Problem Symptom Confirmation
4 Symptom Simulation
5 DTC Check
HINT:
See page BC-82.
6 Problem Symptoms Table
HINT: ...
For vehicles equipped with mobile communication systems
FOR VEHICLES EQUIPPED WITH MOBILE COMMUNICATION SYSTEMS
(a) Install the antenna far away from the ECU and
sensors of the vehicle electronic systems as
possible.
(b) Install an antenna feeder at least 20 cm (7.87 in.)
away from the ECU and sensors of the vehicle
electronic systems. For de ...