Toyota Sienna Service Manual: Brake control
- Anti-lock brake system
- How to proceed with troubleshooting
- Test mode procedure
- Problem symptoms table
- Diagnosis system
- Dtc check / clear
- Freeze frame data
- Data list / active test
- Diagnostic trouble code chart
- Vehicle stability control system
- System description
- How to proceed with troubleshooting
- Calibration
- Test mode procedure
- Terminals of ecu
- Dtc check / clear
- Freeze frame data
- Data list / active test
- Diagnostic trouble code chart
- Problem symptoms table
- Brake actuator (w/ vsc)
- Brake actuator (w/o vsc)
- Front speed sensor
- Rear speed sensor (for 2wd)
- Rear speed sensor (for 4wd)
- Yaw rate and deceleration sensor
- Brake actuator (w/o vsc)
- Steering angle sensor
- Brake system
- Brake fluid
- Brake pedal
- Brake master cylinder
- Brake booster
- Front brake
- Rear disc brake
- Rear drum brake
Installation
1. INSTALL TIRE PRESSURE WARNING RESET SWITCH
(a) Engage the 2 claws to install the tire pressure
warning reset switch to the lower instrument panel
finish panel sub-assembly LH.
2. INSTALL LO ...
Anti-lock brake system
Parts location
...
Other materials:
Magnetic clutch relay
ON-VEHICLE INSPECTION
1. INSPECT MAGNETIC CLUTCH RELAY
(a) Remove the magnetic clutch relay.
(b) Measure the resistance according to the value(s) in
the table below.
Standard resistance
If the resistance is not as specified, replace the
magnetic clutch relay. ...
Precaution
1. SRS AIRBAG SYSTEM HANDLING PRECAUTIONS
This vehicle is equipped with an SRS
(Supplemental Restraint System) such as the driver
airbag and front passenger airbag. Failure to carry
out service operations in the correct sequence could
cause unexpected SRS deployment during
servicing an ...
EVAP System
RELATED DTCS
If any EVAP system DTCs are set, the malfunctioning area can be determined
using the table below.
NOTICE:
If the 0.02 inch reference pressure difference between the first and
second checks is greater than
the specification, the DTCs corresponding to the refe ...
