Toyota Sienna Service Manual: Brake master cylinder

Installation

1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY (a) Install the brake pedal support sub-assembly with the 4 nuts. Torque: 16 N*m (160 kgf*cm, 12 ft.*lbf) (b) Install the clip and clevis pin to the b ...

Removal

NOTICE: Do not adjust the brake booster push rod. Do not change the combination of the diameter converting unit and brake. 1. DRAIN BRAKE FLUID NOTICE: Wash the brake fluid off immediatel ...

Other materials:

Problem symptoms table
HINT:  Before performing verification listed in the table below, check the fuse and relay.  Check the circuits for each problem symptom in the order given in the table below, and proceed to the relevant page. CLEARANCE SONAR SYSTEM: *1: with Front Clearance Sonar *2: wit ...

Data list / active test
HINT: By accessing the DATA LIST displayed on the intelligent tester, you can perform such functions as reading the values of switches and sensors without removing any parts. Reading the DATA LIST as the first step in troubleshooting is one method to shorten labor time. 1. DATA LIST FOR CENTER ...

On-vehicle inspection
1. INSPECT REAR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT REAR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)  Perform a diagnostic system check.  When the quarter panel of the vehicle or ...