Toyota Sienna Service Manual: BRK relay

Light control relay

ON-VEHICLE INSPECTION 1. LIGHT CONTROL RELAY  Inspect relay resistance. Resistance ...

Wiper and washer

...

Other materials:

IG Power Source Circuit
DESCRIPTION The main power source is supplied to the A/C amplifier when the ignition switch is turned to the ON position. The power source is used for operating the A/C amplifier and servo motor, etc. WIRING DIAGRAM INSPECTION PROCEDURE HINT: Start the engine before inspection. Check ...

Display Signal Circuit between Radio and Navigation Assembly and Television Camera Assembly
DESCRIPTION This is the display signal circuit of the television camera assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK HARNESS AND CONNECTOR (RADIO AND NAVIGATION ASSEMBLY - TELEVISION CAMERA ASSEMBLY) Disconnect the R10 connector from the radio and navigation assembly. &nbs ...

Evaporative Emission Control System Pressure
DTC P0450 Evaporative Emission Control System Pressure Sensor / Switch DTC P0451 Evaporative Emission Control System Pressure Sensor Range / Performance DTC P0452 Evaporative Emission Control System Pressure Sensor / Switch Low Input DTC P0453 Evaporative Emission Control System Pressure Sens ...