Toyota Sienna 2010-2026 Owners Manual: Calling the message sender
Calls can be made to an e-mail/SMS/MMS message sender’s phone number.
- Display the message inbox screen.
- Select the desired message.
- Select
. - Check that the “Call” screen is displayed.
Calling from a number within a message Calls can be made to a number identified in a message’s text area.
This operation cannot be performed while driving.
- Display the Message Inbox screen.
- Select the desired message.
- Select the text area.
- Select
corresponding to the
desired number. - Check that the “Call” screen is displayed.
Calling from the incoming message screen
Replying to a message
Display the message inbox screen.
Select the desired message from the list.
Select “Quick Message”.
Select the desired message.
Select “Send”.
If an error message is displayed, f ...
Using the steering
wheel switches
The steering wheel switches can be used to operate a connected
cellular phone.
Operating a telephone using the steering wheel switches
Volume switch
Increase/Decrease the volume
Pres ...
Other materials:
Only Back Door cannot be Opened
DESCRIPTION
With power back door: The signal for manual locking/unlocking operation of
the driver/passenger side
door and the signal for locking/unlocking operation interlocked with the driver
side door key cylinder are
sent to the back door ECU from the body ECU using the MPX line. In respon ...
On-vehicle inspection
1. INSPECT STEERING PAD (VEHICLE NOT INVOLVED IN COLLISION)
Perform a diagnostic system check.
With the steering pad installed on the vehicle,
perform a visual check. If there are any defects as
mentioned below, replace the steering pad with a
new one:
Cuts, minute cracks or ...
TC and CG Terminal Circuit
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter the
self-diagnostic mode. If a
malfunction is present, DTCs will be output.
HINT:
When a particular warning light remains blinking, a ground short in the wiring
of terminal TC of the DLC3
or an internal ground ...
